Skip to content
+1 (718) 500-3046 sales@starcona.com
 
See our Featured Bundle Deals. Aoralscan | MetiSmile | Accufab Bundle  Shop Now
See our Featured Bundle Deals. Aoralscan | MetiSmile | Accufab Bundle  Shop Now
   (718) 500-3046
PowerResins Surgical Guide

PowerResins

PowerResins Surgical Guide

SKU POWERRESINEU SG-1
$139.99 - $239.99
$239.99
$139.99 - $239.99
$239.99

Autoclavable, Rigid Surgical Guide Resin


PowerResins SG resin is a transparent CE certified Class Ia biocompatible, autoclavable with standard protocols, clear and rigid surgical guide resin perfectly formulated for guided implant surgeries. 3D printing with exceptional mechanical properties provides you the best full arch multi unit implant guides cost effectively. Easy to insert drill sleeves directly after printing. Perfectly can be used as gingivectomy guides and bone reduction guides.

  • High flexural strength and modulus guided surgeries
  • Transparent, odorless and tasteless
  • MMA-free organic chemistry formulation, odor-free
  • Can be sterilized via autoclave at 121-125 degrees celsius

Find the validated 3D printer list and settings here

Read full description

Size: 1 kg
Request a quote

Material properties:

Tensile strength
41.1 MpaASTM

Flexural strength
104.2 MpaASTM

Flexural modulus
2800 MpaASTM

Shore hardness
83.6 DASTM

Density
1.1 g/cm3 at 23 CASTM

Viscosity
520-540 mPa.s at 23 CDIN

Color
Translucent white

Post process:

1- Washing

After the printing is completed, wash the part as attached to the building plate with ethyl alcohol (>%90) or isopropyl alcohol (>%90) for 5 minutes. Make sure that alcohol covers the part entirely when washing. Use a brush to remove uncured resin if needed. Do not over-wash, it may cause deterioration in dimensions of the part.

2- Drying

Use air-compressor to dry the washed part. Make sure that the part is dry and uncured resin is cleaned up completely. If still uncured resin left on the part, wash it with fresh alcohol and dry again.

3- Part Removal

Remove the printed part from the building plate using a scraping tool. Be very careful not to damage the model.

4- Post Curing

You can reach 99 MPa flexural strength after curing Please cure 20 minutes with MEDIFIVE curing chamber at 3rd-degree light intensity Otoflash curing recommendations; 104 MPa flexaural strength with 5000 flashes with out gas.

Storage conditions:

Store the PowerResins SG bottle in dark and moisture free place at room temperature (20-24 °C).

Do not forget shaking the resin well before use.

If your printer has a heater, you can set the temperature at 32 °C. Otherwise, you can heat your resin by submerging in hot water for 15-20 minutes.