Skip to content
+1 (718) 500-3046 sales@starcona.com
 
See our Featured Bundle Deals. Aoralscan | MetiSmile | Accufab Bundle  Shop Now
See our Featured Bundle Deals. Aoralscan | MetiSmile | Accufab Bundle  Shop Now
   (718) 500-3046
PowerResins Model

PowerResins

PowerResins Model

SKU POWERRESINEU M-2
$84.99 - $154.99
$84.99
$84.99 - $154.99
$84.99

PowerResins Model resin is a ceramic-based 3D-printing dental model resin with exceptional dimensional accuracy, a low shrinkage rate, and a unique texture and color. Now, printing fixed or removable dental prosthetics, crown and bridge removable die models, implant analog models, wax-up models, and thermoforming models orthodontic aligners is easy.

  • High-detailed prints, easy-to-control margin lines, and anatomical details
  • Thermoforming models for orthodontic applications
  • MMA-free organic chemistry formulation, odor-free
  • Produced under ISO standards 13485:2016

Find the validated 3D printer list and settings here

Read full description

Size: 500g
Request a quote

Material properties:

Tensile strength
26.2 MpaASTM

Flexural strength
99 MpaASTM

Flexural modulus
2640 MpaASTM

Shore hardness
76.75 DASTM

Density
1.1 g/cm3 at 23 CASTM

Viscosity
200-225 mPa.s at 23 CDIN

Color
Light pink

Post process:

1- Washing

After the printing is completed, wash the part as attached to the building plate with ethyl alcohol (>%90) or isopropyl alcohol (>%90) for 5 minutes. Make sure that alcohol covers the part entirely when washing. Use a brush to remove uncured resin if needed. Do not over-wash, it may cause deterioration in dimensions of the part.

2- Drying

Use air-compressor to dry the washed part. Make sure that the part is dry and uncured resin is cleaned up completely. If still uncured resin left on the part, wash it with fresh alcohol and dry again.

3- Part Removal

Remove the printed part from the building plate using a scraping tool. Be very careful not to damage the model.

4- Post Curing

You can reach 99 MPa flexural strength after curing Please cure 20 minutes with MEDIFIVE curing chamber at 3rd-degree light intensity Otoflash curing recommendations; 10000 flashes without gas. After post curing, supports should be removed from the model cautiously.

Storage conditions:

Store the PowerResins Model bottle in dark and moisture free place at room temperature (20-24 °C).

Do not forget shaking the resin well before use.

If your printer has heater, you can set the temperature at 32 °C. Otherwise, you can heat your resin in a microwave for 18 seconds or by submerging in hot water for 15-20 minutes.