Skip to content
+1 (718) 500-3046 sales@starcona.com
 
Unlock Digital Dentistry with Starcona + Ackuretta and Save $900 Visit Promotion
Unlock Digital Dentistry with Starcona + Ackuretta and Save $900 Visit Promotion
   (718) 500-3046
PowerResins Burn 2

PowerResins

PowerResins Burn 2

SKU POWERRESINEU B
$299.99 - $299.99
$299.99
$299.99 - $299.99
$299.99

100% Ash-Free Rapid Burnout Castable Resin


PowerResins BURN 2 resin is reformulated as 100% ash-free castable resin for excellent quality speed burnout for dental direct metal partial frameworks, chrome-cobalt casting as well as excellent for lithium disilicate press applications for inlay, onlay and overlay, laminate and veneer models. You will not face with any investment cracks or expansion during your casting process and can be used with any dental investment/gypsums brand.

  • 100% ash-free burnout for dental fast burnout chrome cobalt casting
  • No investment cracks or expansion
  • Lithium disilicate inlay, onlay, overlay, laminate and veneer models
  • Produced under ISO standards 13485:2016

Find the validated 3D printer list and settings here

Read full description
Request a quote

Material properties:

Tensile strength
14.4 MpaASTM

Flexural strength
20.7 MpaASTM

Flexural modulus
472 MpaASTM

Shore hardness
70.5 DASTM

Density
1.08 g/cm3 at 23 CASTM

Viscosity
490-510 mPa.s at 23 CDIN

Color
Green

Post process:

1- Washing

After the printing is completed, wash the part as attached to the building plate with ethyl alcohol (>%90) or isopropyl alcohol (>%90) for 5 minutes. Make sure that alcohol covers the part entirely when washing. Use a brush to remove uncured resin if needed. Do not over-wash, it may cause deterioration in dimensions of the part.

2- Drying

Use air-compressor to dry the washed part. Make sure that the part is dry and uncured resin is cleaned up completely. If still uncured resin left on the part, wash it with fresh alcohol and dry again.

3- Part Removal

Remove the printed part from the building plate using a scraping tool. Be very careful not to damage the model.

4- Post Curing

No need post UV curing! Enjoy your casting.

Storage conditions:

Store the PowerResins Model bottle in dark and moisture free place at room temperature (20-24 °C).

Do not forget shaking the resin well before use.

If your printer has heater, you can set the temperature at 32 °C. Otherwise, you can heat your resin in a microwave for 18 seconds or by submerging in hot water for 15-20 minutes.